Ericsson AVP 1000 1RU, Reference Manual, Page: 248 / 508

Web GUI Control
5-72
EN/LZT 790 0023/1 R16A
Table 5.39 Video Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed, Minimum, 2 to 20
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm.
Master TS Off, On Sets the master Transport Stream for the component.
Vertical Blanking Interval / Ancillary Data Configuration
VBI Stream and ANC/DVB Subtitle Stream
The following parameters are available on the VBI tab of the Properties widget on
the Service Configuration page when a video stream is selected in the Outputs
widget. The same parameters can be accessed through the Advanced/CE-
x/Video/Video 1/Input/VBI Extraction menu on the front panel.
Table 5.40 VBI Stream and ANC/DVB Subtitle Stream Parameters
Parameter Values Description
Generic ANC
Generic ANC
Extraction Off, On Controls whether Generic ANC is extracted from the SDI
stream or not as per SMPTE 2038-2008.
Max ANC Bit Rate 100 to 2000 kbps The maximum data rate of the Generic ANC data output.
VBI in Picture
Enable VBI in picture Off, Closed Caption
Input Detection
The CE-a J2K VCM supports video input detection as described in Chapter 3,
Getting Started: How to Configure and Use Input Detection.
5.5.3.2.2 Audio Stream Configuration
Audio Input
The following parameters are available on the Input tab of the Properties widget on the
Service Configuration page when an audio component is selected in the Outputs widget.
The same parameters can be accessed through the Advanced/CE-a J2K/Audio
Module/Audio <n>/Input menu on the front panel.
Table 5.41 Audio Input Parameters
Parameter Values Description
Input Format Uncompressed (LPCM), Dolby E Sets the input format used by the audio encoder.
Input Source Off, Mute, Test Tone, Embedded 1 to 8, Input 1 -
4 Sets the source used by the audio encoder. No input is fed
to the encoder if Off is selected. Mute mutes the incoming
audio and encodes silence. Test Tone encodes a 1 kHz
test tone, Embedded 1 to 8 sets the source to an SDI
embedded audio stream. Input 1-4 are for the digital
inputs.