Ericsson AVP 1000 1RU, Reference Manual, Page: 200 / 508

Web GUI Control
5-24
EN/LZT 790 0023/1 R16A
5.4.4 Configuring Option Cards Using the Device Configuration Page
This section gives the tables of parameters available for configuring the option cards
using the
Device Configuration web page.
5.4.4.1 CE VCM Option Cards
It is recommended that the configuration of the CE VCM option cards is done
through the
Service Configuration web page.
5.4.4.2 ASI Option Card
The ASI Option module provides ASI outputs for the transmission of MPEG-2
Transport Streams. When an ASI option module is fitted in a base chassis the host
detects its presence and adds the option to configure a Transport Stream to be
output over ASI.
5.4.4.2.1 ASI Output Configuration
The following parameters are available through the Advanced Setup tab of the
Device Configuration page under Slots > Slot <n> - ASI IO Option Card > ASI IO
Option Card > ASI Output Streams . The same parameters can be accessed
through the Advanced/ASI/ASI Output Streams menu on the front panel.
Table 5.3 ASI Output Configuration Parameters
Parameter Values Description
Output Mode Mirrored, Independent
Specifies whether the two outputs output the same
Transport Stream or they operate independently. If set to
Mirrored, only one output will be accessible.
5.4.4.3 G.703 Transceiver Card
The section describes the options available to set up the G.703 output through the
web user interface or the front panel. When a G.703 Transceiver card is fitted in a
base chassis the host detects its presence and adds the option to configure a
Transport Stream to be output over it.
5.4.4.3.1 Transmitter Configuration
The following parameters are available through the Advanced Setup tab of the
Device Configuration page under Slots > Slot <n> - G.703 Transceiver Card >
G.703 Transceiver Card > G.703 I/O Ports > G.703 I/O Port 1 . The same
parameters can be accessed through the Advanced/ G.703 Transceiver
Card/G.703 I/O Ports/G.703 I/O Port 1 menu on the front panel.