Ericsson AVP 1000 1RU, Reference Manual, Page: 104 / 508

Getting Started
3-62
EN/LZT 790 0023/1 R16A
4. Only the first service in a Transport Stream is available in the Simplified View.
Additional services may be configured, but need to be accessed using the
Advanced View.
5. The input monitor shows the status of the components in the first service of the
main output.
6. When multiple outputs are available and configured, the output for which the
Simplified View supports configuration of TS parameters is determined in the
following order:
- Satmod – if fitted and configured.
- IP – if fitted and configured.
- ASI – if configured.
This cannot be modified.
7. When outputs are mirrored the common configurable parameters of the mirrored
output will be read only (so bit rate and encryption can only be set for the main
output). There is the ability to set each output ON or OFF.
8. When the outputs are independent and have been configured with different
BISS keys the Advanced View must be used to enable/disable encryption,
otherwise the key will be replaced with BISS key 1.
9. A Remux service must NOT be the first service in the output TS as:
- The Simplified View will reject a Remux service as a non-supported
configuration. Ensure that the first service contains components encoded in
the box.
- A Remux service can be the second service, but there is no visibility or
access to this service from the Simplified View.
10. A Pass-thru transport stream is not recognised as a supported output
configuration for the Simplified View. The advanced view needs to be used for
this configuration.
11. Current alarm status is reported on the Simplified View but alarm masking needs
to be performed using the Advanced View.
12. A browser refresh may be needed to update the display to show some changes
made using other interfaces (e.g. via front panel). This applies to both Simplified
View and the Advanced View.
13. Some unlicensed features are displayed but an attempt to configure the feature
will result in an error message pop-up stating not enough licenses and the
configuration will be rejected.
14. Limited Video Profiles. The Simplified View only supports configuring MPEG-2
Main profile (main level for SD or high level for HD) and H.264 High (level 3.1 for
SD or level 4.1 for HD) profiles. This means:
- It is not possible to configure SD H264 Main Level 3.0, SD H264 High Level
3.0 or HD H264 Main level 4.0, which are available on the Advanced View.