Ericsson AVP 1000 1RU, Reference Manual, Page: 244 / 508

Web GUI Control
5-68
EN/LZT 790 0023/1 R16A
Parameter Values Description
Insertion Timeout Timeout in seconds for insertion of default source ID.
Broadcaster ID Mode Off, Auto, Default Only, Source Only Gives what to insert as a broadcaster ID.
Default Servicename The default service name to be used.
Broadcaster ID Source No, Input, Default Indicates if the Broadcaster ID is derived from the input,
the default or is invalid.
Broadcaster ID The Broadcaster ID that is currently being inserted into the
output stream.
Generic ANC
Generic ANC Extraction Off, On Controls whether Generic ANC is extracted from the SDI
stream or not as per SMPTE 2038-2008.
Max ANC Bit Rate 100 to 2000 kbps The maximum data rate of the Generic ANC data output.
Field 1
VBI Line 9 - VBI Line 22 Off, Closed Caption Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, Closed Caption for closed caption information.
Visible for 480i (525-line) input streams.
VBI Line 6 - VBI Line 23
Off, VITC, WSS, WSS-AFD, Teletext System
B, Monochrome samples Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signaling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext. Visible for 576i (625-line)
input streams.
Field 2
VBI Line 272 - VBI Line
285 Off, Closed Caption Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, Closed Caption for closed caption information.
Visible for 480i (525-line) input streams.
VBI Line 319 - VBI Line
336 Off, VITC, WSS, WSS-AFD, Teletext
System B, Monochrome samples Specifies the content in the respective VBI lines. Set to Off
if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signalling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext.
ANC Component
This section describes the parameters associated with the component carrying
ancillary data.
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when an ANC stream is selected in the
Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/<component name>
menu on the front panel.