Dynapac V5100TV-H, Application, Operation & Maintenance

Page: 83 / 196

D 41
6.4 Insulation monitor
The function of the protective insulation
monitoring measure must be checked
every day before starting work.
A
This check only checks the function of
the insulation monitor, not whether an in-
sulation error has occurred on the heat-
ing sections or consumers.
- Start the paver finisher's drive engine.
- Press test button (71).
- The indicator lamp integrated into the
test button signals "insulation fault".
- Press reset button (72) for at least
3 sec. to delete the simulated fault.
- The indicator lamp goes out.
f If the test is conducted successfully,
work may be undertaken with the screed
and external consumers may be used.
If the "insulation fault" indicator lamp dis-
plays a fault even before the test button is pressed or if no fault is displayed during
the simulation, work must not be undertaken with the screed or with connected, ex-
ternal equipment.
f
The screed and equipment must be checked or repaired by a specialist electri-
cian. Only then may work again be undertaken with the screed and equipment.
f
Danger due to electrical voltage
f
Non-adherence to the safety precautions and safety regulations
when operating the electric screed heater leads to a risk of elec-
tric shock.
Danger to life.
All maintenance and repair work on the screed's electrical system may be car-
ried out by a specialist electrician only.
72
71