Dynapac V5100TV-H, Application, Operation & Maintenance

Page: 101 / 196

E 7
The following steps must be carried out to enable the side shields to be folded in front
of the walkway plates when swivelled up:
- Dismantle the lower part of the side shield:
- Lower side shield using crank (4).
- Secure the front mounting bracket (5) in the top position with the cotter pin.
- Unhinge the lower part of the side shield (6) from the chains of the upper part.
- Unscrew side shield upper part and screed from each other:
dismantle assembly parts (9).
- Fit the lower part of the side shield (6) back in position again correctly.
- Swivel walkway plates on left and right and secure with springs (10) in eyelet/
hole (11).
- Swivel first the left and then the right side shield into the transport position in front
of the walkway plates and secure firmly here:
- Set latch (12) over the tab (13).
A
To lock correctly, the two supports (14) must engage in the round steel bar (15). If
necessary, lift the side shields slightly to permit this or adjust the crowning to +/-1%.
m Risk of damage to equipment!
The screed must not be extended when the side shields are locked!