Dynapac V5100TV-H, Application, Operation & Maintenance

Page: 85 / 196

D 43
6.5 Commissioning and checking the
heater
A
In order to reach the required tempera-
ture, the heater should be switched on
approx. 15 - 20 minutes before the start
of paving.
- Switch on the paver finisher's engine.
- Switch on heating system ON / OFF
switch (74) (
o
)
.
- Switch on the control and monitoring
unit ON / OFF switch (105).
- Switch on the electrically heatable
side shields' (
o
) ON / OFF switch
(83).
The heating system is activated and the
heating process begins.
During the heating process, the individu-
al screed section heaters' indicator
lamps (79-81) and the status displays
(109) of the control and monitoring unit
light up.
Once the set temperature has been
reached, the indicator lamps go out one
after another.
Once all screed parts have reached the
desired temperature, paving operation
may begin.
If additional heating occurs during pav-
ing operation, this is indicated by the in-
dicator lamps (79-81).
A
The heater indicator lamps (109) in the
control and monitoring unit can addition-
ally be monitored.
3
74
79
4
105
109
80 81 82