Dynapac V5100TV-H, Application, Operation & Maintenance

Page: 156 / 196

F 20
8.2 Adjusting the ignition burner
To ensure proper ignition, the adjusting
ring (1) of the ignition burner must be ad-
justed.
- Loosen the fastening screws of the
adjusting ring.
- The adjusting ring (1) should cover
roughly 50% of the air holes (2).
- Tighten the fastening screws of the
adjusting ring again.
8.3 Injectors of the gas heater system
The injectors for preparing the gas/air
mixture are not subject to any mainte-
nance intervals.
Impurities in the propane gas may soil
the filter.
In this case, unscrew the screwed fitting
(3) and then the gas nozzle (4). The filter
is connected with the gas nozzle. Care-
fully clean the filter using air.
m Never use a pointed object to clean the
gas nozzle and the filter since this could
damage the filter or the bore hole of the
gas nozzle.
A
The screwed fitting (3) and the gas noz-
zle (4) have been glued-in at the factory
using "Loctite blue".
After cleaning, glue in the gas nozzle (4)
and the screwed fitting (3) and screw
them down.
f Make sure that all gas pipe connections
are firmly screwed together.
Danger of explosions in case of leaks.
1
2
3
4