Dynapac PL350 TD, Instruction Manual

Page: 63 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
Emergency braking
2
1
Fig. Control panel
1. Emergency stop
2. Ignition lock
For emergency braking, press the emergency stop
(1), hold the steering wheel firmly and be prepared
for a sudden stop. The engine stops. For emergency braking, press the emergency stop
(1), hold the steering wheel firmly and be prepared
for a sudden stop. The engine stops.
When emergency stop is activated: The diesel engine
stops, the hydrostatic transmission brakes and the
Multi-disc in the front motor actuates.
After emergency braking, turn ignition key (2) to
position "II" to start the diesel engine.
Parking
Fig. Control panel
1. Hours of operation 2. Ignition lock
1
2
Parking/Switching off
Always park the machine on the most level surface.
Never park the machine with running engine! Never park the machine with running engine!
Before leaving the machine:
Lower the machine until the milling drum almost
touches the ground.
- Read off status for working hours (1) and check if
any maintenance is need before switching off the
machine.
- Switch off the engine and pull out the ignition key. (2)
Close the vandalism protection and lock.
Fig. Battery disconnector
Master switch
At the end of the shift, switch off the battery
disconnector and remove the key.
This will prevent battery discharging and will also
make it difficult for unauthorized persons to start and
operate the machine. Lock the service doors/covers.
55