Dynapac PL350 TD, Instruction Manual

Page: 55 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
Milling depth indicator Position stop
1
2
Fig. Position stop milling depth
1. Crank
2. Locking lever
Adjustable position stops for milling depth can be
found on each chassis leg.
When the desired milling depth has been set, this level
can be locked using a position stop.
Turn the shaft to the desired position using the crank
(1). Lock the shaft in position with the locking lever (2).
Before the milling depth can be increased, the
position stop must first be undone and the shaft
cranked up. Before the milling depth can be increased, the
position stop must first be undone and the shaft
cranked up.
Flow valve
1
Fig. Flow valve
1. Flow valve
Adjusting the speed to raise/lower the two chassis legs
is performed with the aid of the relevant flow valve. (1)
The chassis legs should move easily.
47