Dynapac PL350 TD, Instruction Manual

Page: 61 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
Milling
Fig. Main control panel
1. Chassis leg left
2. Chassis leg right
3. Water pump
4. Control lever 5. Speed adjustment
5
3
2
1
4
When all preparations have been completed the
milling can start while the machine is stationary:
- Lower the machine until the milling drum scrapes
lightly against the ground with the two switches
"chassis leg, right and left" (1, 2).
- Set the milling depth indicators to zero on both sides.
(see section Milling depth indicators, adjustment)
- Carefully lower the machine to required milling depth
(1, 2). The milling depth is shown on the respective
milling depth indicators.
- Set the water pump in the AUTO position (3)
- Move the machine by moving the control lever (4)
from neutral.
- If necessary, adjust to the appropriate speed (5).
The sprinkler system and automatic functions for
the conveyor belt will engage as soon as the
milling drum is in operation and the control lever
is activated. The sprinkler system and automatic functions for
the conveyor belt will engage as soon as the
milling drum is in operation and the control lever
is activated.
5
Fig. Control panel
1. Control lever
2. Leveling 3. Chassis leg left
4. Chassis leg right
5. Milling drum drive
6. Water pump
7. Gear position switch
1
2
3
7
4
6
Stop milling
- Stop the machine and put the control lever (1) in
neutral.
- If automatic levelling has been used, swich off this
function by putting the Automatic mode switch (2) in
position 0.
- Raise the machine evenly using the switches for
chassis leg left (3) and chassis leg right (4) until the
requisite ground clearance is reached.
- Allow the milling drum drive (5) and the water pump
(6) to run for a few minutes and then switch off these
functions.
Drive away from the area:
- Set the gear position switch (7) in transport mode.
Drive the machine forward by moving the control lever
(1) slowly forward.
53