Dynapac PL350 TD, Instruction Manual

Page: 91 / 107

Maintenance - 250h
IPL350TD-1EN2.pdf 2012-06-18
Maintenance - 250h
Make sure that ventilation (extraction) is
adequate if the engine is run in poorly ventilated
areas. Risk of carbon monoxide poisoning. Make sure that ventilation (extraction) is
adequate if the engine is run in poorly ventilated
areas. Risk of carbon monoxide poisoning.
Place the planer on a level surface.
The engine must be switched off during all
checks and adjustments of the planer, unless
otherwise specified. Place the planer on a level surface.
The engine must be switched off during all
checks and adjustments of the planer, unless
otherwise specified.
Battery
Checking the electrolyte level
The batteries are situated under the cover plate (1)
located on the control panel. Undo the screws and
remove the cover plate.
1
Fig. Battery compartment 1. Cover
plate 2. Screws
Make sure there are no naked flames in the vicinity
when checking the fluid level. Explosive gas is
produced in the battery. Make sure there are no naked flames in the vicinity
when checking the fluid level. Explosive gas is
produced in the battery.
Wear safety goggles. The battery contains acid,
which is corrosive. In the event of contact with
the acid, rinse with water. Wear safety goggles. The battery contains acid,
which is corrosive. In the event of contact with
the acid, rinse with water.
When disconnecting the battery, always
disconnect the negative cable first. When
connecting the battery, always connect the
positive cable first. When disconnecting the battery, always
disconnect the negative cable first. When
connecting the battery, always connect the
positive cable first.
The cable shoes should be clean and tightened.
Corroded cable shoes should be cleaned and greased
with acid-proof Vaseline.
83