Dynapac PL350 TD, Instruction Manual

Page: 104 / 107

Maintenance - 2000h
IPL350TD-1EN2.pdf 2012-06-18
Fig. Planetary gear/position for filling
1. Drain plug
2. Filler plug
1
2
Drive wheel - Planetary gear, oil draining
The oil is first changed after 50 working hours and
then every 2000 hours, although at least once a year.
Position the planer so that the drain plug (1) in the
planetary gear is at "6 o clock" and the filler plug (2) at
"9 o clock".
- Unscrew the drain plug. Drain the oil into a container.
Oil should be taken to your local waste disposal
station. Oil should be taken to your local waste disposal
station.
- Screw tight the drain plug.
- Fill new oil through the filler hole the the lower edge
of the level hole. Use transmission oil. See lubrication
specification. Screw tight the filler plug.
Fig. High-pressure hydraulic filter 1.
Filter holder 2. Indicator
2
1
High-pressure hydraulic filter - Replacement
The filter units must always be replaced in pairs! The filter units must always be replaced in pairs!
When the indicator (2) indicates red, the filter must be
replaced. Release the filter holder with an Allen key.
Unscrew by hand.
Remove the filter (1) and hand in to a waste
disposal station. This is a disposable filter and
cannot be cleaned. Remove the filter (1) and hand in to a waste
disposal station. This is a disposable filter and
cannot be cleaned.
Make sure that the old seal is not left on the filter
head. Leakage will otherwise occur between the
new and old seal. Make sure that the old seal is not left on the filter
head. Leakage will otherwise occur between the
new and old seal.
Thoroughly clean the sealing surfaces on the filter
head. Apply a thin coat of fresh hydraulic fluid on the
new filter seal. Screw tight the filter by hand.
Red indicator (2) resets itself automatically after
replacement.
96