Dynapac PL350 TD, Instruction Manual

Page: 77 / 107

Maintenance - Maintenance schedule
IPL350TD-1EN2.pdf 2012-06-18
Every 50 hours of operation (Weekly)
Refer to the contents to find the page number of the
sections referred to !
Pos.
in fig Action Comment Pos.
in fig Action Comment
10 Check/clean air filter and dust container Replace as required 10 Check/clean air filter and dust container Replace as required
15 Check oil level in planetary gear/drive wheel Top up if necessary 15 Check oil level in planetary gear/drive wheel Top up if necessary
7 Check rubber protection, milling housing Replace if necessary 7 Check rubber protection, milling housing Replace if necessary
Lubrication of steering unit, crown wheel Lubrication of steering unit, crown wheel
21 Check side plates Replace if necessary 21 Check side plates Replace if necessary
After the FIRST 250 hours of operation.
Refer to the contents to find the page number of the
sections referred to !
Pos.
in fig Action Comment Pos.
in fig Action Comment
16 Change oil in planetary gear, drive wheel See section "Drive wheel -
Planetary gear, oil draining"
(2000 hours) 16 Change oil in planetary gear, drive wheel See section "Drive wheel -
Planetary gear, oil draining"
(2000 hours)
16 Adjust visible screws/nuts, planetary gear/drive wheel 16 Adjust visible screws/nuts, planetary gear/drive wheel
Every 250 hours of operation (Monthly)
Refer to the contents to find the page number of the
sections referred to !
Pos.
in fig Action Comment Pos.
in fig Action Comment
20 Check condition of batteries Top up if necessary 20 Check condition of batteries Top up if necessary
Check condition of fan Check condition of fan
10 Clean air filter unit 10 Clean air filter unit
15 Check slide plates, chassis leg Adjust if necessary 15 Check slide plates, chassis leg Adjust if necessary
Lubricate spindle, milling depth gauge Lubricate spindle, milling depth gauge
69