Dynapac PL350 TD, Instruction Manual

Page: 93 / 107

Maintenance - 250h
IPL350TD-1EN2.pdf 2012-06-18
Milling depth, limit position
Fig. Milling depth indicator, spindle
Apply grease on the spindle for the milling depth
indicators on both sides. 1 pump stroke with manual
grease gun. Every 250 hours or more frequently if
necessary.
Use grease as per the lubricant specification. Use grease as per the lubricant specification.
Diesel engine - Oil change - Filter replacement
The drain cock for the oil (1) is located on the
right-hand side of the machine frame, by the chassis
leg.
Run the engine warm before draining the oil.
1
Fig. 1. Drain cock
Switch off the engine before draining. Switch off the engine before draining.
Place a suitable container under the drain plug.
Collect up the oil and hand in to waste disposal
station. Place a suitable container under the drain plug.
Collect up the oil and hand in to waste disposal
station.
Danger of being burned when draining hot oil.
Protect your hands. Danger of being burned when draining hot oil.
Protect your hands.
Recycle old filters for waste disposal. Recycle old filters for waste disposal.
Open the cover on the drain cock.
Fit a hose (option).
Open the drain cock with a spanner and allow all the
oil to run out.
Close the cock, remove the hose and refit the cover.
85