Dynapac PL350 TD, Instruction Manual

Page: 45 / 107

Machine description
IPL350TD-1EN2.pdf 2012-06-18
Bits - Checking - Fitting/Removing
Fig. Removing bits
The condition of the bits should be checked several
times a day. Replace immediately if there are visible
signs of wear, unsusual vibrations during milling or
other damage.
Removing of damaged or worn bitl:
Place the hammer punch in the hole on the back of the
tool holder and knock out the bit with a hammer.
Clean the holes and contact surfaces before fitting
new teeth!
Fig. Fitting bits
Fitting new bit:
- Knock in the new bits in the tool holders with a
hammer.
Use copper, brass or plastic hammers!
Steel hammers damage the tip of the milling tooth! Use copper, brass or plastic hammers!
Steel hammers damage the tip of the milling tooth!
Make sure after fitting that the bits can rotate and is
not jammed = less wear on tool.
37