Dynapac PL350 TD, Instruction Manual

Page: 60 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
7
4
6
1
2
5
8
Fig. Main control panel
1. Chassis leg left
2. Chassis leg right
3. Gear position switch
4. Engine speed control, diesel engine
5. Milling drum drive
6. Water pump
7. Speed limitation 8. Leveling function
3
Milling preparations
Check all the hydraulic functions on the machine
before milling! Check all the hydraulic functions on the machine
before milling!
Do not start milling if a warning lamp on the
control panel comes on! Check what the lamp
means and rectify the fault. Do not start milling if a warning lamp on the
control panel comes on! Check what the lamp
means and rectify the fault.
- Lower the machine manually as far as possible
without the milling drum coming into contact with the
ground with the two switches "chassis leg, right and
left" (1, 2).
Activate the following functions on the control panel:
- Put the gear position switch (3) in working mode
(tortoise).
- Set the speed control for the engine (4) at full power.
- Put the milling drum drive (5) in the ON position.
- Put the water pump (6) in the AUTO or 1 position.
- Set the speed (7) in the desired position.
- Set the leveling function in position 1 (8) (Function
option)
52