Dynapac PL350 TD, Instruction Manual

Page: 57 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
Milling instructions
Fig. Milling position
Milling position
Machine lowered - Milling drum lowered
Resetting milling depth
Fig. Resetting
The milling drum is run at low rotational speed.
Lower the drum until the bits scrape against the
ground, along the full width of the drum.
Reset the scale for the milling depth.
Resetting must be performed on right rear
foldable leg, both when folded in and folded out.
Always reset on a horizontal, not inclined surface. Resetting must be performed on right rear
foldable leg, both when folded in and folded out.
Always reset on a horizontal, not inclined surface.
49