MesCom
– Workshop Manual – D6000/i14/V10
© Dycon Ltd 2014
-
72
19 Appendix 6 Event descriptions
All MesCom events are stored in the same format the elements of an event log are:
<uint>Sequence Number
– sequential numbering of events may be useful to identity
duplicate or missing events.
<uint>Value
– Instantaneous value of point or system event number.
<8bit>Point
– number of point(255 for system events).
<2bit>Type
– type of event (0-System, 1-Alarm, 2-Restore, 3-Rountine).
<3bit>State
– current state.
<3bit>Point Type
– points currently defined type or system event sub type.
<7bytes>Time
– time and date of event.
<8bits>Status Flags
– flags to help manage the actions relating to the log.
19.1 Appendix 6.1 System Event Descriptions
General
Radio Module
Runtime Errors
Value
PointType = 0
PointType = 2
PointType = 1
0
Suppression mode
Failed SMS
Watchdog reset
1
System started
Failed to disconnect
Illegal instruction reset
2
Suppression mode Disabled
Module powered on
Point error
3
Brown out restart
Failed to switch module on
Unknown point type
4
NVM ID mismatch
Module off unexpectedly
Unknown point
5
New firmware detected
Module on unexpectedly
Res not defined
6
Logs erased
Failed to switch module off
State machine error
7
Initialisation failed
SMS error
NVM erase
8
Not registered
NVM write
9
Failed to register
NVM command
10
SMS received
ADC channel error
11
SMS response sent
Stack overflow
12
Routine call
13
Carrier lost during call
14
Radio module rebooted
15
Corrupt log found
16
Failed to connect
17
Failed to attached to APN
18
Failed unsol
19
Invalid contact detected
20
Call maximum length reached
21
Message wait time reached
22
Message Corrupt
23
Ring-back requested
24
Incoming call detected
25
Failed email
26
No SMTP server defined
27
Restart requested
253
Log overflow
254
Log buffer overflow
System event PointType = 3 are factory test reports which are not covered in this document.
