Draytek Vigor2762 series, User Manual

Page: 504 / 651

-i [parameter] It means to send information request to server.
-e[parameter] It means to enable or disable the DHCPv6 client.
1: Enable
0: Disable
Example Example
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
> system reboot
Telnet Command:
Telnet Command:
ip6 dhcp server
ip6 dhcp server
This command allows you to configure DHCPv6 server.
ip6 dhcp server [-<command> <parameter>| ... ]
Syntax Description
Syntax Description
Parameter Description
server It means the dhcp server settings.
[<command>
<parameter>|…] The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-a It means to show current DHCPv6 status.
-i<pool_min_addr> It means to set the start IPv6 address of the address pool.
-x<pool_max_addr> It means to set the end IPv6 address of the address pool.
-d<addr> It means to set the first DNS IPv6 address.
-D<addr> It means to set the second DNS IPv6 address.
-c<parameter> It means to send rapid commit to server.
1: Enable
0: Disable
-e<parameter> It means to enable or disable the DHCPv6 server.
1: Enable
0: Disable
Example
Example
> ip6 dhcp server -d FF02::1
> ip6 dhcp server -i ff02::1
> ip6 dhcp server -x ff02::3
> ip6 dhcp server -a
% Interface LAN has following DHCPv6 server settings:
% DHCPv6 server disabled
% maximum address of the pool: FF02::3
Vigor2762 Series User’s Guide 494