Draytek Vigor2762 series, User Manual

Page: 558 / 651

Telnet Command:
Telnet Command:
qos setup
qos setup
This command allows user to set general settings for QoS.
Syntax
Syntax
qos setup [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter Description
[<command>
<parameter>|…] The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-h Type it to display the usage of this command.
-m <mode> It means to define which traffic the QoS control settings will
apply to and eable QoS control.
0: disable.
1: in, apply to incoming traffic only.
2: out, apply to outgoing traffic only.
3: both, apply to both incoming and outgoing traffic.
Default is enable (for outgoing traffic).
-i <bandwidth> It means to set inbound bandwidth in kbps (Ethernet WAN only)
The available setting is from 1 to 100000.
-o <bandwidth> It means to set outbound bandwidth in kbps (Ethernet WAN
only). The available setting is from 1 to 100000.
-r <index:ratio> It means to set ratio for class index, in %.
-u <mode> It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.
-p <ratio> It means to enable bandwidth limit ratio for UDP.
-t <mode> It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
-V Show all the settings.
-D Set all to factory default (for all WANs).
[…] It means that you can type in several commands in one line.
Example
Example
> qos setup -W 2 -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
Setup WAN2 !!!!
WAN2 QOS mode is both
inbound bandwidth set to 9500
outbound bandwidth set to 8500
WAN2 class 3 ratio set to 20
WAN2 udp bandwidth control set to enable
WAN2 udp bandwidth limit ratio set to 50
WAN2 Outbound TCP ACK Prioritizel set to enable
QoS WAN2 set complete; restart QoS
Vigor2762 Series User’s Guide 548