Draytek Vigor2762 series, User Manual

Page: 498 / 651

Telnet Command:
Telnet Command:
ip
ip
maxnatuser
maxnatuser
This command is used to set the maximum number of NAT users.
Syntax
Syntax
ip maxnatuser user no
Syntax Description
Syntax Description
Parameter Description
User no A number specified here means the total NAT users that Vigor
router supports.
0 – It means no limitation.
Example
Example
> ip maxnatuser 100
% Max NAT user = 100
Telnet Command:
Telnet Command:
ip
ip
policy_rt
policy_rt
This command is used to set the IP policy route profile.
Syntax
Syntax
ip policy_rt [-<command> <parameter> | ... ]
Syntax Description Syntax Description
Parameter Description
<command><parameter>|…] The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
General Setup for Policy Route
-i [value] Specify an index number for setting policy route profile.
Value: 1 to 60. “-1” means to get a free policy index automatically.
-e [0/1] 0: Disable the selected policy route profile.
1: Enable the selected policy route profile.
-o [value] Determine the operation of the policy route.
Value:
add – Create a new policy rotue profile.
del – Remove an existed policy route profile.
edit – Modify an existed policy route profile.
flush – Reset policy route to default setting.
-1 [any/range] Specify the source IP mode.
Range: Indicate a range of IP addresses.
Any: It means any IP address will be treated as source IP address.
-2
[any/ip_range/ip_subnet/d
omain]
Specify the destination IP mode.
Any: No need to specify an IP address for any IP address will be
treated as destination IP address.
ip_range: Indicates a range of IP addresses.
ip_subnet: Indicates the IP subnet.
domain: Indicates the domain name.
-3 [any/range] Specify the destination port mode.
Vigor2762 Series User’s Guide 488