Douwe Egberts Cafitesse 100, Service Manual

Page: 85 / 210

07.2004
5A - 3
Functions - Water System Service Manual Cafitesse 100
A.2.1 Disassembly of the Inlet Valve
Preparation:
• Switch off the dispenser and disconnect it
from the mains supply.
• Disconnect the dispenser from the water
supply.
• Loosen the screw (2) and remove the
operating panel cover (1). (Fig. 1)
• Remove the front cover and the advertising
panel (3) towards the side. (Fig. 1)
CAUTION: When the front cover is made
of glass, there is the danger of
being injured due to incorrect
handling or breaking of the
glass.
• Remove the cooling compartment lid (4).
(Fig. 1)
• Remove the housing cover (6). (Fig. 1)
• Remove the air duct (7). (Fig. 1)
• Remove the rear housing wall (5). (Fig. 1)
• Drain the water from the boiler.
(see chap. 5A.2)
• Put the boiler drainage hose (8) aside. (Fig. 2)
Disassembly:
• Loosen the screws of the inlet valve (9).
(Fig. 2)
• Push the inlet valve completely into the
dispenser (inlet spout) and remove it
towards the top.
• Disconnect the cable harness contacts from
the inlet valve (10). (Fig. 3)
• Place a cloth underneath the dispenser and
make sure that there is no water running
out of the valve or inlet hose into the power
supply console.
• Loosen the inlet hose (11). (Fig. 3)
Assembly:
• Assembly is done in the reverse order.
Fig. 2
xxx
xx
xxx
xx
ST
OP
xxxxx
Fig. 1
4
6
7
5
2
1
3
9
8
Fig. 3
10
11