Douwe Egberts Cafitesse 100, Service Manual

Page: 27 / 210

2 - 13
Installation / Putting into Operation Service Manual Cafitesse 100
07.2004
xxx
xx
xxx
xx
ST
OP
xxx
xx
Fig. 4
6
7
Fig. 3
1
3
4
• The dispenser may be installed on a flat,
even counter, table, base stand or on a
wall-mounted table.
• If there are no even installation surfaces,
the dispenser must be aligned.
• A minimum clearance of 5 cm (1.97 in)
must be maintained at the back panel of
the dispenser to ensure enough cooling.
• 2 packagings are supplied:
1. Standard dispenser
2. Country kit with national accessories.
• Measure the water pressure (see chap. 2.4).
• Measure the supply voltage.
• Unpack the dispenser (see chap. 2.3).
• Place the dispenser on a table.
• Remove the operating panel cover (1), the
front cover (2), the housing cover (3) with
cooling compartment lid (4) and air duct (5)
(Fig. 3).
CAUTION: When the front cover is made
of glass, there is the danger of
being injured due to incorrect
handling or breaking of the
glass.
• Adhere the cooling compartment sticker of
the country kit on the inside of the cooling
compartment lid (4) (Fig. 3).
• Lift the floater wire (7) from transport
position and place it above the operating
lever (6) of the float microswitch (Fig. 4).
2
5