Douwe Egberts Cafitesse 100, Service Manual

Page: 60 / 210

4 - 10
Programming Service Manual Cafitesse 100
07.2004
• The dispenser types Cafitesse 110/120 and
café cool are equipped with the same
EPROM (Software). The software
automatically identifies the dispenser type
and indicates it in the service device.
• For the different dispenser types, the
relevant part of software will be loaded
automatically.
• If the pot delivery button is deactivated,
settings regarding pot delivery will not be
effective.
• Programming steps for setting espresso, café
cool or coffee concentrate (Frappé) are only
valid for the corresponding dispenser types.
The settings do not affect other dispenser
types.
• The software can be programmed for
dispensers
either
-
with facelift design
or
-
without facelift design.
• If the software is set to "machine =110/120"
(with facelift design), buttons 1 and 2 of
Cafitesse 120 dispenser can be programmed
for espresso or normal delivery. Button 3 is
always set to espresso.
• If the software is set to "machine=old" (with-
out facelift design), buttons 2 and 3 of
Cafitesse 120 dispenser can be programmed
for espresso or normal delivery. Button 1 is
always set to espresso.
• The settings of the counting and indicating
modes do not affect dispensers without
counters.
4.1.2 Programming Description
• Ratios for cups and pots can be set
individually.
The delivery mode setting (portion,
continuous, repeated) of the café cool
button depends on the setting of the
cup button.
• Coin modules and card readers can be
connected with one- and two-price lines.
• Before programming dispensers which are
equipped for the delivery of espresso, café
cool or coffee concentrate (Frappé), observe
that the bridges (1, Fig. 1) on the I
2
C
interface board espresso/café cool must be
- both opened for the delivery of
espresso.
- both closed for the delivery of café cool.
- one open and one closed for the
delivery of coffee concentrate.
Fig. 1
1