Desoutter Delta Wrench 150 Nm, User Manual, Page: 70 / 184

Part Number
Issue
Date
Page 6159937790
12
03/2018
70 / 184
03/2018 70 (184)
After the power on sequence, the main menu is shown on the display:
Main menu
- Demo Mode : This menu enters the free test, without the need of programming the Delta Wrench
with a specific tightening program (for further details, refer to the paragraph
“
Executing a Demo Test
”).
-
Pset : This menu enters the tightening programs ( Pset ) defined and sent to the Delta
Wrench by DeltaQC (f
or further details, refer to the paragraph “
Pset
”).
-
Settings : This menu sets the language, the date/time, the Demo Mode measurement unit
and enters the diagnostic menu (for further details refer to the paragraph
“Delta
Wrench Settings”
).
- Results This menu shows the last 99 Pset results
NOTE : After 90 seconds of inactivity, the Delta Wrench enters the Power Save Mode,
reducing the display brightness. Press any button on the keyboard to exit the Power Save
Mode.
After about 5 minutes of inactivity, the Delta Wrench switches off automatically; this function
is disabled while the Delta Wrench is performing a test or when it is connected to the
DeltaQC or when the WLAN connection is enabled.
5.1 Manual Zero Adjustment
The Manual Zero Adjustment of the transducer and gyroscope prevents both Zero Gyro and Zero
Torque changes over time.
It can be performed in four different cases (provided the Delta Wrench is in a fixed position without
applying any torque to the transducers):
When the “
main menu
” is
shown
When the “
Demo Mode
”
screen is shown
When the “
Psets
” screen
is shown
For each measure
screen (in the above
example: “Track mode”)