Desoutter Delta Wrench 150 Nm, User Manual, Page: 177 / 184

Part Number
Issue
Date
Page 6159937790
12
03/2018
177 / 184
177 (184) 03/2018
16.2 Angle Correction Coefficient
When an extension is used, the angle correction coefficient allows linear compensation of extension
torsion due to the torque applied. The value is expressed in degrees at the Delta Wrench capacity.
To calculate the proper angle correction coefficient, the torque coefficient of the extension must be
already calculated (as described above) and specified in the Pset used for calculating the angle
correction coefficient.
Thus, follow the procedure below:
1. Create a Pset with the following parameters:
- Control strategy : Torque & Angle
- Torque correction coefficient : 1
-
Target torque : 80% of the Delta Wrench capacity
-
Cycle start and Angle threshold : 10% of Delta Wrench capacity
-
Minimum angle : 0
-
Target angle : 15
-
Maximum angle : 30
-
Check RE-HIT : Disabled
For instance, it could be a proper Pset for a Delta Wrench with
30 Nm capacity: