Dell Command Line Interface, User Manual

Page: 75 / 226

omconfig: Managing Components Using the Instrumentation Service
75
omconfig chassis remoteaccess
NOTE:
This command is applicable to PowerEdge x 8 xx and x 9 xx systems only.
Use the omconfig chassis remoteaccess command to configure:
• Remote access on a local area network (LAN).
• The serial port for BMC or RAC, whichever is installed.
• The BMC or RAC on a serial over LAN connection.
• Terminal settings for the serial port.
• Advanced settings for a serial over LAN connection.
• Information on a BMC or RAC user.
NOTE:
You have to enter the user ID to configure user information.
Type:
omconfig chassis remoteaccess
Table 4-11. omconfig chassis memorymode
name=value pair 1 Description
index=< n> Number of the chassis where the memory module resides (the default is chassis 0, the
main system chassis).
redundancy=spare |
mirror | disabled | raid5 Spare disables the memory module that has a correctable memory event and copies the
failing module’s data to a spare bank.
Disabled indicates that the system is not to use other available memory modules if
uncorrectable memory events are detected.
Mirror switches the systems to a mirrored copy of the memory if the failing module has
an uncorrectable memory event. In mirror mode, the operating system does not switch
back to the original module until the system reboots.
RAID5 is a method of system memory configuration. This is logically similar to the
RAID 5 mode used in hard drive storage systems. This memory mode gives you an extra
level of memory checking and error recovery at the expense of some memory capacity.
The RAID mode supported is RAID level 5 striping with rotational parity.