Dell Command Line Interface, User Manual

Page: 166 / 226

166
Using the Storage Management Service
Example Syntax
For example, to resume a check consistency on virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=resumecheckconsistency controller=1
vdisk=4
omconfig Delete Virtual Disk
Use the following omconfig command syntax to delete a virtual disk.
NOTICE:
Deleting a virtual disk destroys all information including file systems and volumes residing on the virtual
disk. You may receive a warning message if you attempt to delete the system or boot partition. However, this
warning message is not generated in all circumstances. You should be certain that you are not deleting the system
or boot partition or other vital data when using this command.
Complete Syntax
omconfig storage vdisk action=deletevdisk controller=id vdisk=id
w
w
on=deletevdisk controller=1 vdisk=4
omconfig Format Virtual Disk
Use the following omconfig command syntax to format a virtual disk.
Complete Syntax
omconfig storage vdisk action=format controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to format virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=format controller=1 vdisk=4
omconfig Reconfiguring Virtual Disks
You can reconfigure a virtual disk in order to change the virtual disk’s RAID level or increase its size by
adding physical disks. On some controllers, you can also remove physical disks.
Complete Syntax
omconfig storage vdisk action=reconfigure controller=id vdisk=id
raid=<c| r0| r1| r1c| r5| r10> size=<size> pdisk=<PDISK>