Dell Command Line Interface, User Manual

Page: 23 / 226

omreport: Viewing System Status Using the Instrumentation Service
23
frontpanel U, P, A Shows whether the front panel button settings,
such as for the Power button and/or Nonmasking
Interrupt (NMI) button (if present on the
system), are enabled or disabled.
fru U, P, A Shows the Field Replaceable Unit (FRU)
information.
info U, P, A Shows a status summary for main system chassis
components.
intrusion U, P, A Shows the status of the system’s intrusion
sensor(s).
leds U, P, A Shows the properties you have set for LEDs to
flash under various alert conditions.
memory U, P, A Shows properties of your system's memory arrays.
nics U, P, A Shows number of NICs installed in your system,
NIC vendor, NIC description, IP address, and
connection status.
ports U, P, A Shows properties for your system’s parallel and
serial ports, such as I/O address, IRQ level,
connector type, and maximum speed.
processors U, P, A Shows properties of your system’s processors,
including speed, manufacturer, and
processor family.
pwrsupplies U, P, A Shows properties of power supplies.
remoteaccess U, P, A Shows general information on remote access.
slots U, P, A Shows properties of your system’s expansion slots
and other slot types.
temps U, P, A Shows the status and thresholds for the system
temperature sensors.
volts U, P, A Shows the status and thresholds for the system
voltage sensors.
storage U, P, A See "Using the Storage Management Service."
system U, P, A Shows a high-level summary of system
components.
Table 3-1. omreport Command Level 1, Level 2, and Level 3 (continued)
Command
level 1 Command
level 2 Command
level 3 User
privilege
required Use