64
•
Operational Reference
Linea2 5GigE Series Camera
Display Name
Feature & Values
Description
Standard
& View
Pulse on: Rejected Line(s)
Trigger
PulseOnInvalidLineTrigger Generate a pulse on the Invalid LineTrigger event.
Frame Active
FrameActive Generate a signal that is active when the Frame
Acquisition is active.
Pulse on: End of Timer 1
PulseOnEndofTimer1 Generate a pulse on the TimerEnd 1 event.
Pulse on: End of Timer 2
PulseOnEndofTimer2 Generate a pulse on the TimerEnd 2 event.
Pulse on: End of Counter 1
PulseOnEndofCounter1 Generate a pulse on the CounterEnd 1 event.
Pulse on: End of Counter 2
PulseOnEndofCounter2 Generate a pulse on the CounterEnd 2 event.
Output Line Pulse Signal
Activation
outputLinePulseActivation
Specifies the input line activation mode to trigger the
OutputLine pulse.
Beginner
DFNC
Rising Edge
RisingEdge Specifies that the trigger is considered valid on the rising
edge of the source signal.
Falling Edge
FallingEdge Specifies that the trigger is considered valid on the falling
edge of the source signal.
Any Edge
AnyEdge Specifies that the trigger is considered valid on the falling
or rising edge of the source signal.
Output Line Pulse Delay
outputLinePulseDelay
Sets the delay, in microseconds, before the output line
pulse signal. Applicable for the OutputLineSource feature.
Beginner
DFNC
Output Line Pulse Duration
outputLinePulseDuration
Sets the width (duration) of the output line pulse in
microseconds.
Beginner
DFNC
Output Line Value
outputLineValue
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF. OutputLineSource
must be SoftwareControlled. If the
outputLineSoftwareLatchControl = Latch , the state of the
pin will change with the outputLineSoftwareCmd
command.
Beginner
DFNC
Active
Active Sets the Output circuit to close.
Inactive
Inactive Sets the Output circuit to open.
Output Line Software Latch
Control
outputLineSoftwareLatchControl
When Off, the selected output line is set with the value in
Output Line Value.
Guru
DFNC
Off
Off Output pin state set by outputLineValue.
Latch
Latch Output pin state set by outputLineSoftwareCmd.
Line Status All
LineStatusAll
Returns the current status of all available line signals, at
time of polling, in a single bit field. The order is Line1,
Line2 ... (RO)
Expert
Output Line Software
Command
outputLineSoftwareCmd
Writing a value of 1 in the bit field applies the Latch value
of the outputLineSoftwareLatchControl and/or executes
the PulseOnSoftwareCmd for any output line programmed
for software control. The feature outputLineSoftwareCmd
can take any binary value and each bit set to 1
corresponds to a Icommand for an Output. Note that
Outputs are numbered from 1 to N, therefore Bit 0 of
outputLineSoftwareCmd corresponds to Output1 (Line 3);
Bit 1 corresponds to Output2 (Line 4) and so on.
This is applicable to OutputLineSource =
Pulse On: where
Software Cmd
(for Pulse mode) or OutputLineSource =
SoftwareControlled
and OutputLineSoftwareLatchControl
=
Latch
(for static states).
Expert
DFNC