16
•
Linea2 5GigE Camera Quick Start
Linea2 5GigE Series Camera
Connectors
The Linea2 5GigE has two connectors:
•
A single
RJ45 Ethernet
connector for control and video data transmitted to/from the host
computer Gigabit NIC. The Linea2 supports Power over Ethernet (PoE). Refer to Ruggedized
RJ45 Ethernet Cables for information on secure cables.
•
A
HD15
connector for camera power, trigger, strobe and general I/O signals. Teledyne DALSA
provides an optional breakout cable; see Mating GPIO Cable Assembly. Refer to HD15 type
Connector Details for pinout specifications.
The following figure of the Linea2 5GigE back end shows connector and LED locations. Refer to
section Mechanical Specifications for details on the connectors and camera mounting dimensions.
Status LED
RJ-45
Connector
HD15
Connector
15
11
5
1
Figure 5: Linea2 5GigE Series
–
Rear View
Powering the Camera
Two options are available for powering the Linea2 5GigE camera:
1.
Power-over-Ethernet (PoE)
2.
Power supply connected to the HD15 connector.
Refer to the Power over Ethernet (PoE) Support section for more information.
Power supplies must meet the requirements defined in Electrical Interface section.
Important:
Connect power via the HD15 connector or PoE,
not both
. Although
Linea2 has protection, differences in ground levels may cause operational issues or
electrical faults. If both supplies are connected and active, the Linea2 will use the I/O
power supply connector.
