Dalsa Linea2 5GigE, User Manual

Page: 68 / 164

Linea2 5GigE Series Camera Operational Reference • 61
Display Name Feature & Values Description Standard
& View
Rotary Encoder Output
Mode
rotaryEncoderOutputMode Specifies the conditions for the Rotary Encoder interface
to generate a valid Encoder output signal. Expert
DFNC
Position Position Triggers are generated at all new position increments in
the selected direction. If the encoder reverses no trigger
events are generated until it has again passed the
position where the reversal started.
Motion Motion The triggers are generated for all motion increments in
either direction.
Rotary Encoder Direction rotaryEncoderDirection Specifies the phase which defines the encoder forward
direction. Expert
DFNC
Clockwise Clockwise Inspection goes forward when the rotary encoder direction
is clockwise (phase B is ahead of phase A).
Counter Clockwise CounterClockwise Inspection goes forward when the rotary encoder direction
is counter clockwise (phase A is ahead of phase B).
Rotary Encoder Input A
Source rotaryEncoderInputASource Selects which input line to assign to the rotary encoder
input A (also known as shaft encoder). Note that the Line
Mode feature must be set to Input. The list of supported
input line sources is device-specific.
Expert
DFNC
Line 1 Line1 Line1 is assigned to the Rotary Encoder Input A.
Line 3 Line3 Line3 is assigned to the Rotary Encoder Input A.
Rotary Encoder Input B
Source rotaryEncoderInputBSource Selects which input line to assign to the rotary encoder
input B (also known as shaft encoder). Note that the Line
Mode feature must be set to Input. The list of supported
input line sources is device-specific.
Expert
DFNC
GND GND Rotary Encoder Input B is not used.
Line 2 Line2 Line2 is assigned to the Rotary Encoder Input B.
Line 4 Line4 Line4 is assigned to the Rotary Encoder Input B.
Rotary Encoder Source
Activation rotaryEncoderSrcActivation Specifies the signal edge(s) used to increment the rotary
encoder. Expert
DFNC
Rising Edge RisingEdge The rotary encoder uses the rising edge of the source
signal.
Any Edge AnyEdge The rotary encoder uses either the rising edge or falling
edge of the source signal.
Rotary Encoder Rescaler
Order rotaryEncoderRescalerOrder Specifies the order in which the multiplier and divider are
applied. Guru
DFNC
Multiplier Divider multiplierDivider The signal is multiplied before being divided.
Divider Multiplier dividerMultiplier The signal is divided before being multiplied.
Rotary Encoder Multiplier rotaryEncoderMultiplier Specifies a multiplication factor for the rotary encoder
output pulse generator.
Beginner
DFNC
Rotary Encoder Divider rotaryEncoderDivider Specifies a division factor for the rotary encoder output
pulse generator.
Beginner
DFNC
Rotary Encoder Position rotaryEncoderPosition Display the position between Input Src A and B.
Guru
DFNC
Input A ahead B SrcA Input A is ahead B.
Input B ahead A SrcB Input B is ahead A.