DGS-6604
m
vrrp priority
CLI Reference Guide
940
vrrp priority
To set the priority of the virtual router, use the
vrrp priority
command in VRRP
interface configuration mode.
To restore the default priority value of the virtual router, use the no form of this
command.
vrrp VRID priority
PRIORITY
no vrrp VRID priority
Default
Priority
: 100
Command Mode
Interface configuration
Usage Guideline
Use this command to control which router becomes the master router. This
command is ignored while the router is the virtual IP address owner.
The router with the highest priority will become the master, and other routers with
lower priority will then become the backups for the virtual router. Each router
should be configured with different priority values. If there is more than one router
accidently configured to have the same highest priority, then one of them will
become the master which depends on which one of them sends the
advertisement packet out first. If the advertisement packets are sent out at the
same time, the primary IP address (see Note 1) will be compared. The router
with greater primary IP address becomes the master.
Note 1
: the primary IP address is the interface IP address that is configured by
the command
"ip address” on page 226
.
Examples
The following example shows how to configure the router with a priority of 200.
Syntax Description
VRID
Specifies the virtual router identifier, which is the number that identifies the virtual
router that the priority is being configured for.
The virtual router identifier is configured with the command
"vrrp ip” on
page 937
.
Range is from 1 to 255.
PRIORITY
Specifies the priority of the virtual router. Higher values equal higher priority.
Range is from 1 to 254
Switch(config)#interface vlan1
Switch(config-if)#vrrp 7 priority 200
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
