DGS-6604
m
area default-cost
CLI Reference Guide
39
area default-cost
The cost of the default summary route sent into a
not-so-stubby area
(NSSA) or
a stub area is defined with the
area default-cost
command in
router
configuration mode. The
no area default-cost
command is used to remove an
assigned default route cost.
area
AREA-ID
default-cost
COST
no area
AREA-ID
default-cost
Default
COST
: 1
Command Mode
Router configuration
Usage Guideline
Use this command only on an Area Border Router (ABR) attached to a stub area
or NSSA.
The two stub area router configuration commands are
area stub
and
area
default-cost
are configured as follows: for all routers and access servers
attached to the stub area, the area should be configured as a stub area using the
area stub option
; the
area default-cost
command is used only on an ABR
attached to the stub area. The
default-cost
provides the metric for the summary
default route generated by the ABR into the stub area.
Example
The following example assigns a default cost of 20 to stub network 10.0.0.0
Verify the settings by entering the
show ip ospf interface
command.
Syntax Description
AREA-ID
Identifier for the NSSA or stub area. The identifier is specified as either a decimal
value or as an IPv4 prefix. COST is not Optional.
COST
COST
for the default summary route used for a stub or NSSA. The acceptable
value is a 24-bit number (0~16777215).
Switch# configure terminal
Switch (config)# router ospf
Switch (config-router)# area 10.0.0.0 default-cost 20
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
