DGS-6604
m
shutdown (interface)
CLI Reference Guide
789
shutdown (interface)
Use this command to disable the port interface. Use the no form of the command
to enable the port interface.
shutdown
no shutdown
Syntax
None
Default
Enabled
Command Mode
Interface configuration
Usage Guideline
Only physical port interfaces are valid for this configuration.
The command will change the state of a port to be disabled. In the disabled state,
the port will not be able to receive or transmit any packets. Using the no
shutdown command, the port will set the port to the enabled state. When a port is
shutdown (disabled), the link status will also be off.
Examples
Below demonstrates using the
shutdown
command to set interface port eth3.1
to the disabled state
Switch(config)# interface eth3.1
Switch(config-if)# shutdown
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
