DGS-6604
m
auto-cost reference-bandwidth
CLI Reference Guide
55
auto-cost reference-bandwidth
Use this command to control how OSPF calculates the default metric for the
interface.The no form of this command will reset the reference bandwidth to the
default value.
auto-cost reference-bandwidth
MBPS
no aut-cost reference-bandwidth
Default
Enabled
MBPS
: 100
Command Mode
Router configuration
Usage Guideline
By default OSPF calculates the OSPF metric for an interface by dividing the
reference bandwidth by the bandwidth of interface. The default value for the
reference bandwidth is 100Mbps. For example, a 100Mbps will have a metric of 1
and a 64K link will have a metric of 1562,
The
auto-cost
command is used to differentiate high bandwidth links. For
multiple links with high bandwidth, specify a larger reference bandwidth value to
differentiate costs on those links.
Before the cost is changed to the manual configuration mode, the cost must be
configured in advance.
Example
This following example shows how to set reference bandwidth to 50 Mbps.
Verify the settings by entering the
show ip protocol ospf
command.
Syntax Description
MBPS
The reference bandwidth in Mbps. The default reference bandwidth is 100 Mbps.
The valid setting is 1 to 4294967.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# auto-cost reference-bandwidth 50
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...