DGS-6604
m
timers bgp
CLI Reference Guide
904
timers bgp
Use this command to adjust BGP network timers. Use the
no
form of this
command to restore the timers to the default value.
timers bgp
KEEP-ALIVE
[
HOLD-TIME
]
no timers bgp
Default
KEEP-ALIVE
: 60 seconds
HOLD-TIME
: 180 seconds
Command Mode
Router configuration.
Usage Guideline
The suggested default value for the KEEPALIVE is one third (1/3) of the
HOLDTIME. The timers configured for a specific neighbor or peer group (by the
command
"neighbor timers” on page 453
) overrides the timers configured for
all BGP neighbors using the
timers bgp
command.
When the minimum acceptable HOLD-TIME is configured on a BGP router, a
remote BGP peer session is established only if the remote peer is advertising a
HOLD-TIME that is equal to, or greater than, the minimum acceptable HOLD-
TIME interval. If the minimum acceptable HOLD-TIME interval is greater than the
configured HOLD-TIME, the next time the remote session tries to establish, it will
fail and the local router will send a notification stating
unacceptable hold time
.
Example
This example shows how to change the
KEEP-ALIVE
timer to 50 seconds and
the
HOLD-TIME
timer to 150 seconds:
Syntax Description
KEEP-ALIVE
Specifies the frequency, in seconds, with which the switch sends KEEPALIVE
messages to its BGP peer. The range is from 0 to 65535.
HOLD-TIME
(Optional) Specifies the interval, in seconds, after not receiving a KEEPALIVE
message that the switch declares a BGP peer dead. The range is from 0 to
65535.
Switch(config)# router bgp 65100
Switch(config-router)# timer bgp 50 150
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...