DGS-6604
m
speed
CLI Reference Guide
876
speed
Use this command to configure the physical port interface speed setting.
speed {10 | 100 | 1000 [master | slave] | auto} [copper | fiber]
Default
It will be auto for 100TX and 1000TX.
It will be fixed to 100 for 100FX.
It will be fixed to 1000 for 1000SX/LX.
Command Mode
Interface configuration
Usage Guideline
Only physical port interfaces are valid for this configuration.
If the specified speed is not supported by the hardware, an error message will be
returned.
100FX is always fixed 100 and full duplex.
1000SX/LX is always fixed to 1000 and full duplex.
Auto-negotiation will be enabled whether the speed is set to auto or duplex is set
to auto. If the speed is set to auto, and duplex is set to fixed mode, then only the
speed will be negotiated. The advertised capability will be the configured duplex
mode combined with all possible speeds. If speed is to set to a fixed speed and
Syntax Description
10
Specifies to set the port speed to transmit at 10 Mbps.
100
Specifies to set the port speed to transmit at 100 Mbps.
1000 [master | slave]
Specifies to set the port speed to transmit at 1000 Mbps.
•
copper port
: If the speed is set to 1000 Mbps, then the port must be
manually set as either a master or a slave port.
•
fiber port
(1000SX/LX): no-negotiation should be configured (i.e. auto-
negotiation disable).
master
(
1000
only) Manually sets a copper port to be the master port.
slave
(
1000
only) Manually sets a copper port to be the slave port.
auto
Specifies to determine the speed through auto-negotiation with its linked partner.
•
copper port
: Specify to determine the speed via auto-negotiation with its
linked partner.
•
fiber port
(1000SX/LX): auto-negotiation enable, auto-negotiation will be
started to negotiate the clock and flow control.
copper
(Combo-port only) Specify that the configuration is for a copper medium.
fiber
(Combo-port only) Specify that the configuration is for a fiber medium.
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...