DGS-6604
m
lldp tx-delay
CLI Reference Guide
399
lldp tx-delay
To set the transmission delay timer use the
lldp tx-delay
command. This delay
timer defines the minimum interval between sending of LLDP messages due to
constantly change of MIB content. Use the no form of this command to return to
the default settings.
lldp tx-delay
SECONDS
no lldp tx-delay
Default
2 seconds
Command Mode
Global configuration
Usage Guideline
The LLDP transmission interval (tx-interval) must be greater than or equal to four
times of transmission delay timer.
Example
This example shows how to set the transmission delay timer to 8 seconds.
The following example configures the transmission delay timer to default value.
Syntax Description
SECONDS
Specifies a delay for sending successive LLDPDU on an interface; valid values
are from 1 to 8192 seconds and should not be greater than 1/4 of the
transmission interval timer.
Switch(config)# lldp tx-delay 8
Switch(config)# no lldp tx-delay
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
