DGS-6604
ip pim join-prune-interval
CLI Reference Guide
302
ip pim join-prune-interval
Use this command to configure a Join/Prune interval value different from the
default (60 seconds).
ip pim join-prune-interval
SECONDS
Default
60 seconds
Command Mode
VLAN interface configuration
Usage Guideline
This command is only valid for the VLAN interface.
This command is valid for SM only.
When configuring the Join/Prune interval, the user needs to consider the factors,
such as configured bandwidth and expected average number of multicast route
entries for the attached network or link (for example, the period would be longer
for lower-speed links, or for routers in the center of the network that expect to
have a larger number of entries).
For SM-mode, the router will periodically send the join message based on this
interval. The hold-time in a Join/Prune message is 3.5 * join-prune-interval. The
receiving router will start a timer based on this hold-time, and prune the interface
if no join message is received on this interface.
Example
The following example changes the PIM Join/Prune timer to 120 seconds.
Verify the settings by entering the
show ip pim interface
command.
Syntax Description
SECONDS
The number of seconds that can be configured for the interval between Join/
Prune messages. The range is 1 to 18000.
Switch(config)# interface vlan1
Switch(config-if)# ip pim join-prune-interval 120
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
