DGS-6604
ip pim register-checksum-include-data
CLI Reference Guide
305
ip pim register-checksum-include-data
Use this command to configure the option to calculate the Register checksum
over the whole packet. Use the no form of this command to disable calculating
the Register checksum over the whole packet.
ip pim register-checksum-include-data { group-list
ACCESS-LIST-NAME
}
no ip pim register-checksum-include-data
Default
Disabled
By default, the Register Checksum is calculated only over the header.
Command Mode
Global configuration
Usage Guideline
This command is valid for SM mode and used to provide compatible inter-
operability with other manufacturer devices per the following:
This command is used to inter-operate with some legacy
CISCO®
manufactured
routers using older
CISCO® IOS™
versions. This command is needed for the
first hop router for encapsulation of the register packet. This function needs to be
enabled in order to inter-operate with legacy
CISCO®
devices using older
IOS™
versions.
If group-list is not specified, then the setting will be applied to all groups.
This command can be only specified once. The later applied command will
override the previous setting.
Example
The following example shows how to enable register checksum over whole
packet.
Verify the settings by using the
show ip pim
command.
Syntax Description
group-list
ACCESS-LIST-NAME
Specifies the name of the basic IP access list name
Switch(config)# ip pim register-checksum-include-data
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
