DGS-6604
m
sflow poller
CLI Reference Guide
571
sflow poller
Use the
sflow poller
command to create/configure a Poller for the sFlow agent.
Use the
no
form of this command to delete one Poller or all Pollers.
sflow poller
INSTANCE
[receiver
RECEIVER
] [interval
SECONDS
]
no sflow poller [
INSTANCE
]
Default
No Poller is created.
Command Mode
Interface configuration mode.
Usage Guideline
The command is available for physical port interface configuration.
A Poller can only be configured on one interface. It cannot be associated with
multiple interfaces.
Use this command without keywords to create a default Poller or to reset an
existing Poller to default values. Use the
no
form of this command with
INSTANCE to delete one Poller. Use the
no
form of this command without
INSTANCE to delete all Pollers.
The user can only specify a Receiver that has its owner name setup. If the
Receiver associated with the Poller has its owner name is reset, the Poller will be
reset to the default setting.
Setting the polling interval to 0 disables the polling.An interface can be
configured with multiple Pollers.
Example
This example shows how to create/configure the Poller of INSTANCE 1 with
RECEIVER as 1, and INTERVAL as 20 seconds.
Syntax Description
INSTANCE
The instance index if multiple pollers are associated with one interface. The
range is from 1 to 65535
receiver
RECEIVER
(Optional) The receiver's
INDEX
for this poller. If not specified, the value is 0. the
user cannot configure the value to 0. The maximum number is project
dependent.
interval
SECONDS
(optional) The maximum number of seconds between successive polling
samples. The range is from 0 to 120. 0 means disable. If not specified, the
default is 0.
switch(config-if)# sflow poller 1 receiver 1 interval 20
Summary of Contents for DGS-6600 Series
Page 1: ...0 9 3 ...
