DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
172
Chapter 18
Debug Software Command List
debug error_log
[dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
debug buffer
[utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output
[module <module_list> | all] [buffer | console]
debug config error_reboot
[enable | disable]
debug config state
[enable | disable]
debug show error_reboot state
debug show status
{module <module_list>}
18-1
debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
Parameters
dump
- Specifies to display the debug message of the debug log.
clear
- Specifies to clear the debug log.
upload_toTFTP
- Specifies to upload the debug log to a TFTP server specified by IP address.
<ipaddr>
- (Optional) Enter the IPv4 address of the TFTP server.
<path_filename 64>
- (Optional) Enter the pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrators can issue this command.
Example
To dump the error log:
Summary of Contents for DGS-1510/ME Series
Page 1: ......
