DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
131
Chapter 15
Configuration Command List
show config
[effective | modified | current_config | boot_up | file <pathname 64>] {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin ] <filter_string 80> {<filter_string 80>
{<filter_string 80>}}}}}
config configuration
<pathname 64> [boot_up | active]
save
{[config <pathname 64> | log | all]}
show boot_file
15-1
show config
Description
This command is used to display the content of the current configuration, the configuration to be used in next boot,
or the configuration file specified by the command.
The output stream of the configuration data can be filtered by the expression specified at the end of the command.
The expression can contain up to three multiple filter evaluations. A filter evaluation begins with a filter type
(include, exclude, and begin), followed by up to three filter strings (ex: “stp”). A filter string is enclosed by symbol ".
The following describes the meaning of the each filter type.
include:
includes lines that contain the specified filter string.
exclude:
excludes lines that contain the specified filter string
begin:
The first line that contains the specified filter string will be the first line of the output.
The relationship of multiple filter strings following the same filter type is OR. That is, one line is qualified if one of
specified filter strings is matched.
If more than one filter evaluation is specified; the output of filtered by the former evaluation will be used as the input
of the latter evaluation.
Format
show config [effective | modified | current_config | boot_up | file <pathname 64>] {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin ] <filter_string 80> {<filter_string 80>
{<filter_string 80>}}}}}
Parameters
effective
- Specifies to only display the commands which affects the behavior of the device. For example, if STP
is disabled, then for STP configuration, only “STP is disabled” is displayed. All other lower level setting
regarding STP is not displayed. The lower level setting will only be displayed when the higher level setting is
enabled. Note that this parameter is only for the current configuration.
modified
- Specifies to only display the commands which are not default setting. Note that this parameter is only
for the current configuration.
current_config
- Specifies the current configuration.
boot_up
- Specifies the list of the bootup configuration.
Summary of Contents for DGS-1510/ME Series
Page 1: ......
