D-Link DGS-1510/ME Series, Reference Manual

Page: 115 / 654

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
111
Parameters
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters long.
<network_address> - Specifies the IPv4 network address (xx.xx.xx.xx/xx). It specifies a host address and length
of network mask.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
state - (Optional) Specifies the state of the IP interface.
enable - Specifies that the IP interface state will be enabled.
disable - Specifies that the IP interface state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an IP interface:
DGS-1510-28XMP/ME:admin# create ipif Inter2 192.168.16.1/24 default state enable
Command: create ipif Inter2 192.168.16.1/24 default state enable
Success.
DGS-1510-28XMP/ME:admin#
10-14 config ipif
Description
This command is used to configure the IP interface.
Format
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> | state [enable | disable]}
| bootp | dhcp | ipv6 [ipv6address <ipv6networkaddr> | state [enable| disable]] | ipv4 state [enable | disable]
| dhcp_option12 [hostname <hostname63> | clear_hostname | state [enable | disable]]]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters long.
ipaddress - (Optional) Specifies a network on an ipif. The address should specify a host address and length of
network mask. Since an ipif can have only one IPv4 address, the new configured address will overwrite the
original one.
<network_address> - Enter the network address used here.
vlan - (Optional) Specifies the name of the VLAN here.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
state - (Optional) Specifies to enable or disable the state of the interface.
enable - Specifies to enable the state of the interface.
disable - Specifies to disable the state of the interface.
bootp - Specifies to use BOOTP to obtain the IPv4 address.