CTC Union GSi 600 Series, Installation And Maintenance Manual

Page: 116 / 136

116 CTC GSi 600
12.10.2 Def. Heating Circuit
Heating Circuit 1 Yes (Yes/No)
Heating Circuit 1 (HC 1) is predefined by the control
system. Heating Circuit 2 is shown on the row
underneath if connected.
Room sensor Yes (Yes/No)
Select "Yes" if room sensors should be connected to the
heating circuit.
Type Wireless (Cable/Wireless/SmartControl)
Select whether the room sensor for the heating circuit
has a wired (via cable) or wireless connection.
• Wireless
Select "Wireless" to connect CTC’s wireless room
sensors to the heating circuit.
Refer to the "CTC Wireless Room Sensor" manual
for information on how to connect these sensors.
• SmartControl
SmartControl is a separate series of wireless
accessories. If "SmartControl" is selected, the
connection channel must be selected in the row
below. SmartControl accessories are connected to
the system via the "Installer/Define/SmartControl"
menu. Refer to the separate SmartControl
Accessories manual.
HC1 Night reduction ext. config.
None (None/NO/NC)
This menu defines the Normally Open (NO) or Normally
Closed (NC) mode for the external control signal when
remotely controlling the function.
For examples of how to set the normal mode, refer to
the "Installer/Define/Remote Control" chapter.
HC1 Heating mode ext. config.
None (None/NO/NC)
This menu defines the Normally Open (NO) or Normally
Closed (NC) mode for the external control signal when
remotely controlling the function.
For examples of how to set the normal mode, refer to
the "Installer/Define/Remote Control" chapter.
Menu: "Installer/Define/Heating Circuit".
Select a heating circuit and press "OK" to access the settings.
Menu: "Installer/Define/Heating Circuit/ Heating Circuit 1".
Wireless room sensor selected.