CTC Union EcoZenith i350 L 1x230V, Installation And Maintenance Manual

Page: 110 / 132

110 CTC EcoZenith i360
12.11.2 Def. heating circuit
Heating circuit 1-* Yes (Yes/No)
Heating circuit 1 (HC 1) is predefined.
The rows under Heating Circuit 1 show the other
definable heating circuits (HC 1-2 in the example).
Room sensor Yes (Yes/No)
Select "Yes" if room sensors should be connected to
the heating circuit.
Type Cable/Wireless/SmartControl
Select whether the room sensor for the heating circuit
has a wired (via cable) or wireless connection.
• Wireless
Select "Wireless" to connect CTC’s wireless room
sensors to the heating circuit.
Refer to the "CTC Wireless Room Sensor" manual
for information on how to connect these sensors.
• SmartControl
SmartControl is a separate series of wireless
accessories. If "SmartControl" is selected,
the connection channel must be selected in
the row below. SmartControl accessories are
connected to the system via the "Installer/Define/
SmartControl" menu. Refer to the separate
SmartControl Accessories manual.
HC1 Night reduction ext. config.
None (None/NO/NC)
This menu defines the Normally Open (NO) or Normally
Closed (NC) mode for the external control signal when
remotely controlling the function.
For examples of how to set the normal mode, refer to
the "Installer/Define/Remote Control" chapter.
HC1 Heating mode ext. config.
None (None/NO/NC)
This menu defines the Normally Open (NO) or Normally
Closed (NC) mode for the external control signal when
remotely controlling the function.
For examples of how to set the normal mode, refer to
the "Installer/Define/Remote Control" chapter.
Menu: "Installer/Define/Heating Circuit".
Select a heating circuit and press "OK" to access the settings.
Menu: "Installer/Define/Heating Circuit/ Heating Circuit 1".
Wireless room sensor selected.