-2 8-
CHASSIS
- 218-
• rake caliper o y
• rake flui eli ery passage rake caliper
o y
Blockage
Blow out with compresse air.
WARNING:
Replace the caliper piston seals and dust
seals whenever the brake caliper is
disassembled.
ASSEMBLING THE REAR BRAKE CALIPER
WARNING:
• All internal brake components should be
cleaned and lubricated with new brake fluid
only before installation.
Must use DOT4 Brake Fluid
• eplace the caliper piston seal and dust
seal whenever a brake caliper is disassembled.
. Install
• caliper piston seal
• ust seal
. Install
• rake caliper piston
Turn the rake caliper piston clockwise until
section
ⓐ
of the rake caliper piston is le el with
the surface of the rake caliper o y.
NOTE:
Align an end
ⓑ
of the groove in the brake
caliper piston with the punch mark
ⓒ
on the
brake caliper body.
CHASSIS
- 219-
3. Install:
• gasket
• parking rake case
• parking rake case olts
22Nm (2.2 m · kg,16 ft · lb)
• O ring
4. Install:
• parking rake arm shaft
• parking rake arm
• set olt
• parking rake arm nut
NOTE:
Apply lithium-soap-based grease to the parking
brake arm shaft and set bolt.
a.
crew in the parking rake arm shaft
counterclockwise completely so that the punch
mark
ⓐ
on the parking rake arm shaft is
etween the alignment marks
ⓑ
.
NOTE:
The hole for the parking brake arm shaft has
multiple threads. If the punch mark
ⓐ
on the
parking brake arm shaft is not between the
alignment marks
ⓑ
when the parking brake
arm shaft is screwed in completely, remove the
parking brake arm shaft and screw it in from a
different starting position.
. Turn the parking rake arm shaft appro
imately
clockwise.
c. Install the parking rake arm to the parking
rake arm shaft so that the punch mark
ⓒ
on the
parking rake arm is aligne with the punch
mark
ⓐ
on the parking rake arm shaft.
. Turn the parking rake arm until it contacts the
pin
ⓓ
.
e. inger tighten the set olt.
f. Tighten the parking rake arm nut.
