-2 4-
CHASSIS
- 204-
BRAKE SYSTEM
PREPARATION FOR CHECKING BEFORE THE
MAINTENANCE OF THE BRAKE SYSTEM.
Brake system is crucial to the life safety of the
operator and therefore must be periodically
inspected and maintained.
This vehicle uses the single return route
hydraulic pressure disc brake system. Please
follow the tips of inspection as below.
. To check the amount of liquid in the oil cup. If
it is min than the minimum mark, refill the box
with the same type of fluid as was recommended
by the manufacturer, to ensure to fluid level is
higher than the minimum mark.
The brake should be kept between
3mm-5mm, Otherwise, please adjust the screw
to meet required travel distance.
1. Inspect the brake pedal does maintain the
certain counter-tension
When checks disk brake plate, the saved liquid
in the oil cup will pour automatically into the
pressure pipe and the liquid level along with it to
reduce, the periodic inspection the disk brake
plate liquid volume will be an important project.
2.
rear disk brake plate
thickness
Periodical inspection of the wear condition of rear
disk brake plate is also necessary. Disk brake
plate must be replaced depending on its wear
condition.
3. Disk brake plate uses hydraulic pressure of the
brake fluid. Therefore, fuel pipe must be
periodically inspected and replaced.
Inspection method: If the oil tubing has the aging,
crack or distortion, must replace the oil tubing.
Must use DOT4 Brake
CHASSIS
- 205-
DISK BRAKE COMPONENTS
No.
Part Name
Qty
Remarks
Removing brake components
1
Front brake pad
2
2
Front right brake oil pipe
1
3
Front left brake oil pipe
1
4
Rear disk brake main tube
1
5
Rear brake pipe (left)
1
6
Rear brake pipe (right)
1
7
Rear brake plate
2
8
Cooper seal
15
9
Strainer bolt
4
